Cherry Aerospace H753A-249NP RIVETLESS NUT PLATE® RIGHT ANGLE PULLING HEAD
H753A-249NP RIVETLESS NUT PLATE® RIGHT ANGLE PULLING HEAD
DIMENSIONAL DATA (see figure, all measurements in Inches) • Tool weight (without riveter): 1.20 Lbs (0.540 Kg).
CHOICE OF RIVETERS • G704B Cherry® Riveter • G800 Cherry® Hand Riveter
MOUNTING INSTRUCTIONS • Attach riveter to air source for correct piston positioning; for hand powered riveters (G750A), make sure that the pressure has been released and that the correct adaptors are used. • Push the collet bolt assembly forward (see Figure 1) before mounting. • While holding collet bolt in a forward position, engage 1 or 2 threads of draw bolt (18) onto riveter head piston before threading adapter fitting (19) into end of riveter head cylinder; turn clockwise until snug. • Rotate pulling head to desired position and tighten jam nut (20) to secure pulling head orientation. • Cycle the tool to make sure it is functional.
USAGE • The H753A-249NP pulling head will install Rivet less Nutplates for metallic structures in holes Ø.249 min.
BEFORE USE, MAKE SURE THAT: • Proper air source is connected. • The sleeve and pilot are in proper working condition; any sign of damage is an indication that components need to be replaced. No installations should be made if tooling is worn or damaged.
DURING OPERATION • Inspect the active area of the sleeve and pilot regularly. • Keep the tool clean, especially the pilot, sleeve and jaws; pay special attention when sealants are used. • If stem slippage occurs, the jaws need to be either cleaned or replaced.
PREVENTATIVE MAINTENANCE • Clean the sleeve, pilot, jaw set and collet every 1,000 installations or when failures occurs; use a wire brush to clean the copper deposited inside the jaw set. • Lubricate outside of the jaw set with Lubriplate® or similar light lubricant.
Questions and answers from customers on this product
There are no questions yet. Be the first to ask a question about this product.
