Cherry Aerospace H828-56MBPS Right Angle Pulling Head for MaxiBolt® Plus fasteners

Cherry Aerospace H828-56MBPS Right Angle Pulling Head for MaxiBolt® Plus fasteners

DIMENSIONAL DATA (all measurements in Inches, )
 Tool weight (without riveter): 2.1 Lbs (0.9 Kg)
CHOICE OF RIVETERS
 G744 Cherry Riveters (no adaptation
necessary)
 G83 or G84 Riveters with Adapters P/N 744-200

ADAPTOR INSTRUCTIONS
 Remove the bayonet mount (if present)
 Thread and tighten adapters 744-200 onto the pulling head 

MOUNTING INSTRUCTIONS
 Attach riveter to air source
 Push the drawbolt assembly forward (see Figure 1)
 While holding drawbolt in a forward position, thread
the pulling head onto the riveter, making sure that both
internal and external threads are connected.
 Use jam-nut to lock the pulling head in position.
 Cycle the tool to make sure it is functional.

BEFORE USE, CHECK IF:
 The proper riveter is selected; the pulling head is correctly
mounted, clean and in proper working condition.
 Proper air source is connected (see riveter specification for recommended pressure).
 The appropriate nose piece is used (“U” or “S” type – see component table 1).
 The jaws provide enough clearance for the BlindBolt® serrated area to fully engage in the tool freely;
o If the pulling head is mounted incorrectly, the spent stems get stuck inside of the jaws.

USAGE
 -5 and -6 diameter MaxiBolt® Plus and EN BlindBolts®
 To Install -5 and -6 BlindBolt® “S” and “U” type, see table 1 in sheet 2

DURING OPERATION
 Inspect the active area of the nosepiece regularly.
 Remove the broken stem by hand after each installation and dispose of them; if the broken stems
get stuck, the jaws do not open enough. Make sure the pulling head is correctly mounted.
 Keep the tool clean, especially the nosepiece and jaws; pay special attention when used with sealants
and adhesives.
 If stem slippage occurs, the jaws need to be either cleaned or replaced